Delta MM300 Bedienerhandbuch PDF herunterladen (Seite 3)

ADDITIONAL SAFETY RULES FOR

HOLLOW CHISEL MORTISERS

1. DO NOT OPERATE THIS MACHINE until it is

assembled and installed according to the instructions.

2. OBTAIN ADVICE FROM YOUR SUPERVISOR,

instructor, or another qualified person if you are not

familiar with the operation of this machine.

3. FOLLOW ALL WIRING CODES and recommended

electrical connections.

4. MAKE CERTAIN the machine is fastened to a supporting

surface to prevent it from tipping over during operation.

5. NEVER turn the mortiser “ON” before clearing the

table of all objects (tools, scrap pieces, etc.).

6. ALWAYS keep hands, fingers and hair away from

the rotating bit.

7. DO NOT attempt to mortise material that does not

have a flat surface, unless a suitable support is used.

8. ALWAYS position holddown directly over workpiece

to prevent workpiece from lifting during operation.

9. ALWAYS support workpiece securely against fence

to prevent rotation.

10. BE SURE drill bit is sharp, not damaged, and properly

secured in the chuck before operation.

11. MAKE SURE chuck key is removed before starting

machine.

12. NEVER turn on the power with the drill bit or chisel

contacting the workpiece.

13. NEVER perform layout, assembly, or set-up work on

the table while the mortiser is operating.

14. ADJUST the depth stop to avoid drilling into the

table.

15. ALWAYS turn off the power before removing scrap

pieces from the table.

16. SHUT-OFF the power, remove the drill bit and chisel,

and clean the table before leaving the machine.

17. FOR YOUR OWN SAFETY – Don’t wear gloves when

operating the machine.

18. SHOULD any part of your tool be missing, damaged, or

fail in any way, or any electrical component fail to perform

properly, shut off switch and remove plug from power

supply outlet. Replace missing, damaged, or failed parts

before resuming operation.

19. THE USE of attachments and accessories not

recommended by Delta may result in the risk of injuries.

20. TURN THE MACHINE “OFF” AND DISCONNECT

THE MACHINE from the power source before installing

or removing accessories, before adjusting or changing

set-ups, or when making repairs.

21. TURN THE MACHINE “OFF”, disconnect the

machine from the power source, and clean the

table/work area before leaving the machine. LOCK THE

SWITCH IN THE “OFF” POSITION to prevent

unauthorized use.

22. ADDITIONAL INFORMATION regarding the safe

and proper operation of this tool is available from the

Power Tool Institute, 1300 Summer Avenue, Cleveland,

OH 44115-2851. Information is also available from the

National Safety Council, 1121 Spring Lake Drive, Itasca,

IL 60143-3201. Please refer to the American National

Standards Institute ANSI 01.1 Safety Requirements for

Woodworking Machines and the U.S. Department of

Labor OSHA 1910.213 Regulations.

WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.

SAVE THESE INSTRUCTIONS.

Refer to them often

and use them to instruct others.

1 2 3 4 5 6 7 8 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Delta MM300 Bedienerhandbuch Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Delta MM300