Delta 43-459 Bedienerhandbuch

INSTRUCTION MANUALPART NO. 432-02-651-0041 - 05-10-04Copyright © 2004 Delta MachineryTo learn more about DELTA MACHINERY visit our website at: www.del

10POSITION OF COLLARS1. The collars may be used in any of three positions:above, below, or between two cutters.2. When the collar is used below the cu

11STARTING PIN1. The machine is supplied with a tapered starting pin (A)Fig. 34, which is used as a support when starting thecut. The starting pin (A)

12PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P

13Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine

14NOTES

15NOTES

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

3GENERAL SAFETY RULES1. FOR YOUR OWN SAFETY, READ THE INSTRUCTIONMANUAL BEFORE OPERATING THE MACHINE.Learning the machine’s application, limitations,

404-24-031. DO NOT OPERATE THIS MACHINE UNTIL it isassembled and installed according to the instructions.2. OBTAIN ADVICE from your supervisor, instru

5Do not expose this machine to rain or operate the machine in damp locations.POWER CONNECTIONSMOTOR SPECIFICATIONSThis machine is not supplied with a

6For your own safety, do not connect the machine to the power source until the machine iscompletely assembled, and you read and understand the entire

7Fig. 8ATTACHING TABLE INSERTSThree table inserts are provided for various size cutters (Fig. 8). The large insert is adjustable.To set it flush with

8ATTACHING ELECTRICAL BOX TO CABINETThe tool is shipped with the starter box wired to the switch and motor and must bemounted to the shaper cabinet.In

9Using the fence is the safest and most satisfactory method of shaping. Most straight work can be shaped using the fencedescribed below.1. For average