INSTRUCTION MANUALPART NO. A10351 - 03-31-05Copyright © 2005 Delta MachineryESPAÑOL: PÁGINA 17To learn more about DELTA MACHINERY visit our website at
10OPERATIONAL CONTROLS AND ADJUSTMENTS8. Open the chuck jaws as wide as possible by turning chucksleeve (T) Fig. 8. Hold the chuck (S) Fig. 8 and care
11LOCKING SWITCH IN THE “OFF” POSITIONIMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthor
12CHANGING SPEEDS AND ADJUSTING BELT TENSION1. Open the top cover (A) Fig. 18.2. Loosen the lock-knob (B) Fig. 18 and the tension knob (located on the
13ADJUSTING THE SPINDLE RETURN SPRINGThe spindle will automatically return slowly to its upper position when the handle is released. The spindle retur
14Fig. 25ABDCNOTE: Use drill bits with a shank of 5/8" or less in diameter.DISCONNECT MACHINE FROM POWER SOURCE.1. Insert the smooth end of drill
15MAINTENANCEPARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a
16Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed
5SAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others.ADDITIONAL SPECIFIC SAFETY RULES1. DO NOT OPERATE THIS MACHINE until it
6A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should beprotected with a 20 Amp ti
You can have your drill press converted to 230 voltoperation.A qualified electrician must perform this conversion. Shouldyou desire to have your drill
8FOREWORDFUNCTIONAL DESCRIPTIONUNPACKING AND CLEANING Carefully unpack the machine and all loose items from the shipping container(s). Remove the prot
9ASSEMBLYASSEMBLY TOOLS REQUIREDASSEMBLY TIME ESTIMATE1. Attach the column (A) Fig. 3 to the base (B) using thefour 1-3/4" bolts (C), three of wh
Kommentare zu diesen Handbüchern