Delta DP350 Bedienerhandbuch

INSTRUCTION MANUAL12" Variable Speed Drill Press(Model DP350)PART NO. 905584 - 01-31-03Copyright © 2003 Delta MachineryTo learn more about DELTA

1010. IMPORTANT: Make certain the spindle taper (Q) Fig.15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rust preventive

11Fig. 18AFLEXIBLE LAMPThe flexible lamp operates independently of the drillpress. To turn the lamp “ON” and “OFF”, rotate switch(A) Fig. 18A.To reduc

12VARIABLE SPEED CONTROLTo avoid damaging the drive belts andpulleys, DO NOT turn speed control handles (A) Fig. 24,unless motor is running. The pilot

13ADJUSTING SPINDLERETURN SPRINGThe spindle is automatically returned to its upper mostposition when the handle is released. It is recommendedthat the

14INSTALLING ANDREMOVING DRILL BITSDISCONNECT MACHINE FROM POWERSOURCE.1. Insert smooth end of drill bit (A) Fig. 29, into chuck(B), as far as it will

15LUBRICATIONDISCONNECT MACHINE FROM POWERSOURCE.1. Remove the six screws (A) Fig. 30 that hold the topcover in place, and remove the top cover. 2. Th

16Printed in U.S.A.Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machin

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder

2Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with

317. REDUCE THE RISK OF UNINTENTIONAL STARTING.Make sure switch is in “OFF” position before plugging inpower cord. In the event of a power failure, mo

A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp tim

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wireextension cord which has a 3-prong grounding type plug a

6DRILL PRESS PARTSFig. 1Fig. 11 - Drill Press Head and Motor2 - Column, Base Flange, and Rack3 - Table4 - BaseFig. 25 - Chuck6 - Clamp Handle7 - Pinon

7FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE I

84. Slide raising rack (F) Fig. 7, table and table bracketonto drill press column, as shown. Make sure bottom ofraising rack (F) Fig. 8, is inside the

97. Thread stud on clamp handle (M) Fig. 12, into hole inrear of table bracket, as shown.8. Place the drill press head (N) Fig. 13, onto thecolumn as