Delta 11-985 Bedienerhandbuch

INSTRUCTION MANUAL10" Bench Drill Press(Model 11-985)PART NO. 900296-0010Copyright © 2000 Delta MachineryESPAÑOL: PÁGINA 17To learn more about DE

10This tool is intended for use on a circuit that has anoutlet and a plug that looks like the one shown in Fig. 19.A temporary adapter, which looks li

11CHANGING SPEEDS ANDADJUSTING BELT TENSIONFig. 23Fig. 241. Disconnect the drill press from the powersource.2. Lift up the belt and pulley guard (A) F

12Fig. 27Fig. 28TABLE ADJUSTMENTS1. The table can be raised or lowered on the drill presscolumn by loosening the table clamp handle (A) Fig. 27,and tu

13Fig. 32Fig. 33Fig. 34Fig. 35DRILLING HOLES TO DEPTHWhere a number of holes are to be drilled to exactly thesame depth, a depth stop is provided in t

14BORING IN WOODTwist drills, although intended for metal drilling, may also be used for boring holes in wood. However, machine spurbits are generally

15NOTES

16Delta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta mach

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

323. NEVER LEAVE TOOL RUNNING UNATTENDED.TURN POWER OFF. Don't leave tool until it comes to acomplete stop.24. DRUGS, ALCOHOL, MEDICATION. Do not

4UNPACKINGYour drill press is shipped complete in one container. Carefully unpack the drill press and all loose items from thecontainer. Figure 2 illu

5CLEANINGRemove the protective coating from the machined surfaces of the drill press and all loose items. This coating may beremoved with a soft cloth

6Fig. 7Fig. 8Fig. 9Fig. 104. Slide raising rack (F) Fig. 7, table and table bracketonto drill press column, as shown. Make sure bottom ofraising rack

7Fig. 11Fig. 12Fig. 13Fig. 147. Figure 11, illustrates the table raising and loweringhandle (K) assembled to worm gear shaft (G).8. Thread table clamp

8Fig. 15Fig. 1611. IMPORTANT: Make certain the spindle taper (Q) Fig.15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rus

9POWER CONNECTIONSA separate 110-120 volt, grounded electrical circuit should be used for your drill press. This circuit should not be lessthan #12 wi