Delta 23-700 Bedienerhandbuch

INSTRUCTION MANUALDATED 6-7-96 PART NO. 1340208©Delta International Machinery Corp. 1996UniversalWet/DryGrinder(Model 23-700)

10Fig. 26Fig. 27TEN INCH WETGRINDING WHEELThe ten inch aluminum oxide grinding wheel operates ata slow speed of 70 RPM, which makes it suitable forhon

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are certainhazards in

3Fig. 3Fig. 4Fig. 2ASSEMBLING ANDADJUSTING EYE SHIELD1. Fasten the eye shield (A) Fig. 2, to mounting bracket(B) using the two screws (C) and nuts (D)

4Fig. 5Fig. 6Fig. 8Fig. 7ASSEMBLINGAND ADJUSTINGTHE TOOL RESTS1. Assemble the tool rest (A) Fig. 5, to the wheel guardusing the lock knob screw (B), n

5Fig. 9ADJUSTINGSPARK DEFLECTORAs the five inch grinding wheel (H) Fig. 9, wears downdue to extended use, the spark deflector (J) should beadjusted do

POWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should beprotected wit

7Fig. 15Fig. 16WATER LEVELWhen using the 10 grinding wheel, there should alwaysbe enough water in the base (A) Fig. 15, of the grinder inorder that on

8Fig. 21Fig. 20Fig. 19Fig. 18Fig. 17DRESSING AGRINDING WHEELWhen dressing a grinding wheel, use a suitable siliconcarbide stick type dresser, as shown

9LUBRICATIONOccasionally lubricate the arbor shaft with light machineoil, through the oiler (A) Fig. 22, provided.To lubricate the worm gears (A) and