Delta 23-710 Bedienerhandbuch PDF herunterladen (Seite 11)

ASSEMBLING AND ADJUSTING

WATER TANK

1. Insert stem (A) Fig. 18, of water tank (B) into holder

Fig. 15

7. Fig. 16, illustrates tool and chisel holder (K) in

position on tool rest base (J).

8. To raise or lower the tool and chisel holder assembly

(E) Fig. 17, refer to STEP 5.

9. To tilt the tool and chisel holder (J) Fig.17, to conform

with the angle of the tool to be sharpened, loosen set

screw (N) and turn knob (H) as necessary. After angle

is set, tighten set screw (N).

10. To move the tool and chisel holder (J) Fig. 17, in or

out, loosen set screw (C), and slide assembly (E) in

or out as desired. After adjustment, tighten screw

(C).

11. To level tool and chisel holder base (J) Fig. 17, with

the wet grinding wheel (G), loosen screw (F) with

supplied wrench, and rotate complete base

assembly (E) until tool and chisel holder base (J) is

level with wet grinding wheel (G), and tighten screw

(F).

Fig. 16

Fig. 17

Fig. 18

6. Place tool and chisel holder (K) Fig. 15, in position on

base (J).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Keine Kommentare

Delta 23-710 Bedienerhandbuch Seite 11