Delta 70-200 Bedienerhandbuch PDF herunterladen (Seite 17)

Fig. 30

TABLE ADJUSTMENTS

1. The table can be raised or lowered on the column by

loosening table clamp handle (A) Fig. 29, and turning the

table raising and lowering handle (B). After the table is at

the desired height, tighten handle (A).

2. The table can be tilted right or left by pulling out and

removing table alignment pin (C) Fig. 30, and loosening

table locking bolt (D). Tilt the table to the desired angle

and tighten bolt (D). A tilt scale and pointer are provided

on the table bracket casting to indicate the degree of tilt.

When returning table to the level position, replace table

alignment pin (C) Fig. 30. This will automatically position

the table surface at 90 degrees to the spindle.

Fig. 31

REMOVING CHUCK

AND SPINDLE ADAPTER

If you desire to remove the chuck and spindle adapter,

lower spindle and rotate chuck until the slot in the

spindle lines up with the slot in the quill, as shown in

Fig. 31. Then insert tapered end of drift bar (A) into slot

(B) in quill and remove chuck and spindle adapter.

1 2 ... 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

Delta 70-200 Bedienerhandbuch Seite 17