Delta 36-L336 Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 21)

TAKING SLACK OUT OF RIVING KNIFE

RELEASE CABLE

Over time, the riving knife release cable may develop slack

and may not fully open the riving knife release clamp. To

remove the slack out of the riving knife release cable:

1. Using a 7/16" open end wrench, move nut (B1)

Fig. 51 (located underneath the fence in front of saw)

away from saw cabinet.

2. Using a 7/16" wrench, tighten nut (D1) against the

bracket (C1) and nut (B1).

To avoid the risk of injury, do not

overtighten the cable. If the cable is too tight, the

riving knife will be loose and will not function properly.

After adjustments always check that the riving knife

is securely clamped in the desired position by firmly

pulling up on the knife.

ALIGNING THE RIP FENCE AND TABLE BOARD

See your fence instruction manual for instructions on

adjusting the rip fence parallel to the miter gauge slot, as

well as instructions for making sure the table board is flat

to the extension wings and flat across the whole width of

saw, wings and table board.

CHANGING THE SAW BLADE

Use only 10" (254 mm) diameter blades

with 5/8" (16 mm) arbor holes, rated at 4,300 rpm or

higher.

To reduce the risk of injury, turn unit off

and disconnect it from power source before installing

and removing accessories, before adjusting or when

making repairs. An accidental start-up can cause injury.

1. Remove the throat plate (FF) Fig. 52, and raise the

saw blade to its maximum height.

2. Remove old blade, if needed, by holding red arbor

lock button (E1) Fig. 52. Use included arbor wrench

to remove the blade retaining nut (F1). Remove old

blade.

3. Place the new blade on the arbor with the teeth

pointing down as the blade rotates toward the front

of the saw table.

4. Replace the blade retaining nut and throat plate.

MAXIMUM BLADE HEIGHT ADJUSTMENT

The saw is designed so that the top of blade can be

raised to a maximum distance of 3-1/8" (79 mm) from

the table surface. If the saw is not achieving this height,

follow these steps:

1. Raise blade to its highest point, then back of slightly.

2. Loosen the blade height stop jam nut (G1) Fig. 53

slightly with a wrench.

FIG. 52

FIG. 51

FIG. 53

3. Set blade height to 3-1/8" (79 mm).

4. Use a hex wrench in the stop bolt to turn the blade height stop into place against the arbor bracket. The stop can be

rotated in either direction until it jams against the trunnion.

5. Hold hex wrench in place and tighten the blade height stop jam nut.

6. Lower the blade and re-position against the blade height stop. Verify the height is still 3-1/8" (79 mm).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare

Delta 36-L336 Gebrauchs- und Pflegehandbuch Seite 21

Kommentare zu diesen Handbüchern