Delta 100 Series Installationshandbuch PDF herunterladen (Seite 44)

IQ 100 Series (130/140/150) Meter

Communication Installations

44 User and Installation Manual IM02601003E-September 2011 www.eaton.com

Conguring the Ethernet Connection (RJ45 Port Option)

The RJ45 port option gives the IQ 100/100T Series meter a wired (RJ45) Ethernet connection speaking

Modbus TCP, allowing it to communicate on a Local Area Network (LAN). The meter is easily cong-

ured through a host PC using a Telnet connection. Once congured, you can access the meter directly

through any computer on your LAN.

This section outlines the procedures for setting up the parameters for Ethernet communication.

Setting up the Host PC to Communicate with the IQ100 Series meter

• Consult with your Network Administrator before performing these steps since some of the functions

may be restricted to Administrator privileges.

• The Host PC could have multiple Ethernet Adapters (Network Cards) installed. Identify and congure

the one that will be used for accessing the meter.

• The PC’s Ethernet Adapter must be set up for point-to-point communication when conguring the

RJ45 port option. The Factory default IP parameters programmed into the RJ45 port are:

IP Address: 10.0.0.1

Subnet Mask: 255.255.255.0

See following sections for additional parameters.

Conguring the Host PC’s Ethernet Adapter Using Windows XP©

The following example shows the PC conguration settings that let you access the IQ 100 Series meter

congured with default parameters. Use the same procedure when the settings differ from the default

settings.

1. From the Start Menu, select Control Panel>Network

Connections. You will see the window shown on the right.

2. Right click on the Local Area Network Connection you will

use to connect to the meter and select Properties from the

drop-down menu. You will see the window shown on the

next page.

IQ 100 Series Transducer Communication Information

The IQ 100 Series Transducer model does not include a display or buttons on the front of the meter.

Programming and communication utilize either the RS485 connection or the optional RJ45 connection

on the back of the meter. Once a connection is established, Eaton Meter Conguration Software can be

used to program the meter and communicate to IQ 100 Series slave devices. Refer to the next chapter

for instructions on programming the meter.

Meter Connection

To provide power to the meter, attach an Aux cable to GND, L(+) and N(-). Refer to page 27.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 93 94

Keine Kommentare

Delta 100 Series Installationshandbuch Seite 44