Delta 40-650 Bedienerhandbuch

1DATED 11-25-98INSTRUCTION MANUALPART NO. 1349463© Delta International Machinery Corp. 199818" Variable Speed Scroll Saw(Model 40-650, Type 2)Qui

10FASTENING STAND TO SUPPORTING SURFACEIf there is any tendency for the scroll saw to move during operation, the scroll saw stand must befastened to t

11Fig. 18DUST BLOWERA dust blower (A) Fig. 18, is provided, and canbe moved to direct air to the most effectivepoint on the cutting line.ADJUSTING BLA

12ADJUSTING CLAMPING ACTION OF BLADE HOLDERSDifferent widths of scroll saw blades will make it necessary to adjust the clamping action of the blade ho

13Fig. 253. Push blade holder clamping lever (C) Fig. 25, to therear as shown. This will automatically release the blade(D) from the upper blade holde

14Fig. 27Fig. 28Fig. 29Fig. 31ADJUSTING 90 AND 45DEGREE POSITIVE STOPSFOR TABLE1. Loosen table lock handle and move the table all theway to the left a

15BRUSH INSPECTIONAND REPLACEMENTCAUTION: BEFORE INSPECTING THE BRUSH-ES, DISCONNECT THE MACHINE FROM THEPOWER SOURCE.Brush life varies. It depends on

16BLADE BREAKAGEBlade breakage is usually caused by one or more of the following:1. Bending the blade during installation.2. Improper blade tension.3.

2TABLE OF CONTENTSSAFETY RULES...

3

4ADDITIONAL SAFETY RULESFOR SCROLL SAWS1. WARNING: Do not operate your scroll saw until it iscompletely assembled and installed according to theinstru

5Fig. 2UNPACKING AND CLEANINGYour new scroll saw and stand is shipped complete in one container. Carefully unpack the saw, stand and all looseitems fr

6Fig. 3ASSEMBLING STAND1. Assemble the stand, as shown in Fig. 4,using the 24 carriage bolts, flat washers andhex nuts. NOTE: The round holes on the t

7Fig. 5Fig. 6Fig. 7Fig. 83. Figure 8 illustrates the saw (H) fastened tothe stand (J). Place the stand on a level sur-face and securely tighten all st

8Fig. 9Fig. 10Fig. 11Fig. 12ASSEMBLINGHOLDDOWN FOOT1. With wrench supplied, assemble holddownfoot (A) Fig. 10, to rod (B) using 1/2² hex sock-et head

9CONNECTING SCROLL SAW TO POWER SOURCEIMPORTANT: BEFORE CONNECTING THE SAW TO THE POWER LINE, MAKE SURE THE SWITCH IS IN THE “OFF”POSITION.Fig. 15Fig.