Delta 31-120 Bedienerhandbuch

INSTRUCTION MANUALPART NO. 900657 (011)Copyright © 2001 Delta MachineryTo learn more about DELTA MACHINERY visit our website at: www.deltamachinery.co

10CHANGINGABRASIVE DISCSMAKE CERTAIN MACHINE IS DISCONNECTEDFROM POWER SOURCE.1. To remove abrasive disc (A) Fig. 21, simply peel oldabrasive disc fro

11NOTES

12PARTS, SERVICE OR WARRANTY ASSISTANCEDelta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expe

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

3ADDITIONAL SAFETY RULES FOR DISC SANDERS1. READ AND UNDERSTAND INSTRUCTION MANU-AL BEFORE OPERATING DISC SANDER.2. IF YOU ARE NOT thoroughly familiar

4Fig. 4UNPACKING AND CLEANINGYour new Disc Sander is shipped complete in one container. Carefully unpack the sander and all loose items from theshippi

5CONNECTING DISC SANDER TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less t

6Fig. 7EXTENSION CORDSUse proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong

7Fig. 10Fig. 11ADJUSTING MITER GAGE SLOT PARALLELWITH THE ABRASIVE DISCMAKE CERTAIN MACHINE IS DISCONNECTED FROM POWER SOURCE BEFORE MAKING ADJUSTMENT

8Fig. 13Fig. 14Fig. 15Fig. 16TILTING THE TABLE ANDADJUSTING THE 45 DEGREEPOSITIVE STOPSMAKE CERTAIN MACHINE IS DISCONNECTEDFROM POWER SOURCE BEFORE MA

92. Loosen table locking handles (A) Fig. 17, and tilt thetable up as shown, to expose lock nut (F) Fig. 18, andscrew (G). Loosen lock nut (F) and ret