Delta 28-278 Bedienerhandbuch

14" Wood CuttingBand Saw(Model 28-278)INSTRUCTION MANUALPART NO. 426-02-651-0039 - 08-31-01Copyright © 2001 Delta MachineryTo learn more about DE

ADJUSTING LOWER BLADE GUIDESAND BLADE SUPPORT BEARINGAdjust the lower blade guides and blade support bearing after the theupper guides and bearing hav

11CUTTING CURVESWhen cutting curves, turn the stock carefully so that the blade will follow without being twisted. If a curve is so abrupt thatrepeate

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are cer-tain

3ADDITIONAL SAFETY RULESFOR BAND SAWS1. IF you are not thouroughly familiar with the operation ofband saws, obtain advice from your supervisor, instru

4Fig. AFig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDINGMEANSADAPTERUse proper exten

ATTACHING MOTOR TO STANDAttach the motor to the stand using four 5/16" x 3/4" carriage bolts (A) Fig. 4 (two of which are shown inserted) th

6ATTACHING BELT GUARD, MOTOR AND ARBOR PULLEYS,AND DRIVE BELT1. Thread the six #10-32 x 5/8" self-tapping screws (A) Fig. 9 about halfway into

77Fig. 9Fig. 14Fig. 11Fig. 10Fig. 12Fig. 13Fig. 16Fig. 15ABACDBFHGECJKBDCLMNLSOVWBTROBP

8Fig.17Fig.18TABLE INSERTPlace the table insert (A) Fig. 17 in the hole provided in the table. Engage the protrusion of the insert in the indent (B) i

9Fig. 21These graduations are correct for average work, and willnot be affected by rebrazing of the saw blade. Use thesegraduations until you become f