Delta 36-312 Bedienerhandbuch PDF herunterladen (Seite 7)

Fig. 5

Fig.6

FENCE OPERATION

The saw is supplied with left fence segment (A) Fig. 7

that incorporates a squeeze clamp feature. To operate

the fence segment or to slide to another location,

squeeze the clamp (A) Fig. 7 to disengage the lock. Slide

the fence to desired location and release to lock the

fence. To remove the fence, depress lever (B) and slide

it off the fence base.

Make sure that the fence is clear of the

guard and blade before operating the saw.

Fig. 7

OPERATION AND ADJUSTMENTS

FASTENING MACHINE TO SUPPORTING SURFACE

Before operating your compound miter saw, firmly mount it to a workbench or other supporting surface. Four holes (A)

Fig. 9 are provided for fastening the saw to a supporting surface.

When frequently moving the saw from place to place, mount the saw to a 3/4” piece of plywood. The saw can then be

easily moved from place to place and the plywood can be clamped to the supporting surface using “C” clamps.

Fig. 9 Fig. 10

MOVING TABLE TO THE 0° CUT-OFF POSITION

1. Rotate the locking knob (A) Fig. 5 counter-clockwise as far as it will go. Depress the lever (B) and rotate the table

NOTE: This saw incorporates a new slotted plate design feature (D) Fig. 6 with location adjustment screws (E) for

fine-adjusting the cutting angle.

2. For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER CUTTING”,

and “ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Keine Kommentare

Delta 36-312 Bedienerhandbuch Seite 7