Delta RS830 Bedienerhandbuch PDF herunterladen (Seite 19)

Fig. 33

Fig. 34

Fig. 36

Fig. 35

4. Loosen cutting-head clamp knob (S) Fig. 33, and

slide cutting-head (T) the entire length of track arm (A) as

shown to determine if blade (C) travels parallel to the

square (E).

5. If an adjustment is necessary, loosen index ring

locking screw (J) Fig. 34, and track arm clamp handle

(K).

6. Rotate track arm (A) Fig. 33, until blade (C) travels

parallel to square (E). Then tighten track arm clamp

handle (K) Fig. 34.

7. With track arm clamp handle (K) Fig. 35, tightened,

rotate index ring (L) counterclockwise until it stops. Then

tighten index ring locking screw (J) Fig. 36.

8. There are two miter index pointers, one of which is

shown at (M) Fig. 36. Adjust as follows: loosen screw (N)

and move pointer (M) until it lines up with the “zero”

mark on the miter scale (P). Then tighten screw (N).

Adjust the miter index pointer located on the other side

of column (R) in the same manner.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Keine Kommentare

Delta RS830 Bedienerhandbuch Seite 19