Delta 23-725 Bedienerhandbuch PDF herunterladen (Seite 12)

Fig. 17

FLEXIBLE LAMP

The flexible lamp operates independently of the grinder.

To turn the lamp on and off, rotate switch (A) Fig. 17.

To reduce the risk of fire, use 40 watt or

less, 120 volt, reflector track type light bulb (not

supplied). A standard household light bulb should

not be used. The reflector track type light bulb

should not extend below the lampshade.

Fig. 18

OPERATION

STARTING AND STOPPING GRINDER

1. The on/off switch (A) Fig. 18 is located on the front of

the grinder. To turn the machine “ON”, move the switch

up to the “ON” position.

2. To turn the machine “OFF”, move the switch (A)

down to the “OFF” position.

MAKE SURE THAT THE SWITCH IS IN

THE “OFF” POSITION BEFORE

PLUGGING IN THE POWER CORD. IN THE EVENT OF A

POWER FAILURE, MOVE THE SWITCH TO THE “OFF”

POSITION. AN ACCIDENTAL START-UP CAN CAUSE

INJURY.

LOCKING SWITCH IN “OFF” POSITION

IMPORTANT: When the machine is not in use, the

switch should be locked in the “OFF” position to prevent

unauthorized use,

using a padlock with a 3/16" diameter

shackle inserted through the holes at (B) FIg. 18.

OPERATIONAL CONTROLS AND ADJUSTMENTS

GRINDING WHEELS

THE USE OF ACCESSORIES AND ATTACHMENTS NOT RECOMMENDED BY DELTA MAY RESULT

IN RISK OF INJURIES.

Grinding wheels used with Model 23-725 grinders should be rated for 1800 RPM or higher and be 8" in diameter with

a 5/8" or 1" arbor hole.

The arbor bushing should be saved, for future use, if the replacement wheel does not use the bushing.

For best grinding results, and to maintain good balance, always keep the wheels properly dressed. Do not force the

work against a cold wheel. The grinding wheel should always be run at idle speed for one full minute before applying

work. It is recommended that only balanced wheels be used with your grinder. The use of balanced wheels adds years

to the life of the bearings on the grinder and by eliminating the most common source of vibration, more accurate work

is accomplished.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Delta 23-725 Bedienerhandbuch Seite 12