Delta 17-925 Bedienungsanleitung PDF herunterladen (Seite 2)

ASSEMBLING THE CHISEL HOLDER

1. Loosely thread the knob (A) Fig. 1 into the bottom of the hole of the chisel holder (B) (See Fig. 2).

2. Install the special screw (C) in either side of the chisel holder (B).

3. Loosely thread the locking lever (D) on the special screw (Fig. 2).

ATTACHING THE CHISEL HOLDER TO THE DRILL PRESS

Disconnect the machine from the power source.

THE FOLLOWING INSTRUCTIONS ARE FOR THE 10", 12", 14", AND 32" RADIAL DRILL PRESSES.

1. Install and lock the smaller diameter end of the alignment pin (A) Fig. 3 into the spindle (B).

2. Lower the drill press spindle (B) Fig. 4 approximately two to three inches and lock the quill (G) in this position.

3. Slide the rubber ring (C) Fig. 4 up on the quill.

4. Select the correct size bushings for your drill press (Fig. A) and attach them around the quill, between the rubber

ring (C) and the stop collar (E) Fig. 4.

5. While holding the bushings (D) Fig. 5 in position on the quill, face the gap in the split-ring bushings toward the front

of the machine.

6. Return the spindle to its uppermost position.

7. Start from below the alignment pin (A) Fig. 6 and slide the chisel holder (H) up, so that the alignment pin (A) enters

the smaller hole in the chisel holder. Check to see that the larger hole in the chisel holder is positioned over the

split-ring bushings (D) Fig. 5.

NOTE: Before you tighten the locking lever (K) Fig. 6, make certain that the slot in the split-ring bushing (F) Fig. 5 aligns

with the slot (L) Fig. 6 in the chisel holder. Tighten the thumb screw (M) first,then tighten the locking lever (K).

NOTE: The locking lever is spring-loaded. Change it by pulling out and repositioning the hub of the lever on the nut

located directly under the hub.

8. Loosen the knob (M) Fig. 6 and remove the alignment pin (A) from the spindle after the chisel holder (H) is attached

to the machine.

9. After successfully completing these instructions, go to the section in this manual entitled “ATTACHING THE

FENCE TO THE TABLE.”

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

C D

1 2 3 4 5 6 7 ... 19 20

Keine Kommentare

Delta 17-925 Bedienungsanleitung Seite 2