Delta 50-850 Bedienerhandbuch PDF herunterladen (Seite 7)

Fig. 15

Fig. 16

Fig. 17

9. Attach the lower dust bag retaining clip (A) Fig. 14A,

to the dust collector drum. Align the two holes (B) in the

retaining clip (A) Fig. 14A, with the two holes in the drum.

Insert a 1/4-20x5/8" hex head screw through the holes in

the retaining clip and the holes in the drum. Place a 1/4"

flat washer onto the screws, and thread 1/4-20 hex nut s

on the screws and tighten securely. Repeat this process

for the three remaining sides of the drum.

ASSEMBLING DUST INTAKE

PORT AND CAPS TO BLOWER

AND MOTOR ASSEMBLY

1. MAKE CERTAIN THE DUST COLLECTOR IS

DISCONNECTED FROM THE POWER SOURCE.

2. Align the four holes in dust intake port (A) Fig. 15,

with the mounting holes in flange (B) of blower and

motor assembly and fasten with four sheet metal screws

(C). Fig. 16 illustrates the dust intake port assembled to

the blower assembly.

3. NOTE: Two dust intake port caps (D) Fig. 17, are

supplied with the dust collector. The caps are to be

placed into the dust intake ports (E) when the intake ports

are not in use.

4. Place the collar of dust cap (D) Fig. 17, over the

opening on intake port. Press recessed side of dust cap

(D) into port opening. IMPORTANT: When connecting

an intake hose to one or both intake ports, DO NOT

REMOVE THE DUST CAP COLLARS (F) FIG. 17 FROM

THE INTAKE PORTS. Pull the dust cap from the port

opening and slide the collar and cap farther onto the

port housing.

Fig. 14A

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Delta 50-850 Bedienerhandbuch Seite 7