Delta SHOPMASTER GR250 Bedienerhandbuch

INSTRUCTION MANUAL6" Variable Speed Grinder / Sharpener(Model GR250)PART NO. 905595 - 05-03-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 13T

10CHANGING GRINDINGWHEELS1. DISCONNECT MACHINE FROM POWER SOURCE.2. When changing wheels, remove the screwsattaching the side covers to the grinder an

11NOTES

12Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3SAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others. ADDITIONAL SAFETY RULES FORGRINDERS1. DO NOT OPERATE THIS MACHINE until

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6GRINDER PARTSFig. 21. Grinder2. 1/4-20x1/4" hex head screw (2)3. 5/16-18x5/8" hex head screw (4)4. Eye shield bolt (2)5. 5/16-18x3/4"

7ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAN

82. Align the holes in the eye shield with the holes in thespark guard and place the eye shield spacer (A) Fig. 7, inthe space in the spark guard as s

9VARIABLE SPEEDCONTROLThe grinder is equipped with a variable speed control (B)Fig. 10. When the variable speed control knob ispositioned to the furth